Tooling Accessories

When you are doing an “adjustable comb conversion”, to a gunstock this is a quick and easy way of marking the exact location for your comb bushing. After the saw cut and inletting for the comb plate, place the transfer plate in the inlet and set the comb piece in place and press down hard or smack-it with heel of hand. Plates are anodized aluminum with hardened steel punches, comes with a removing screw.

Different than most other ‘pad sanding fixtures”, this unit has an 1 ½” wide base plate that will not tilt when sawing or sanding. The top plate is 4” long with a series of small slots to accept #10 screws, for holding hardware type plates for bandsawing, belt sanding or disc sanding. Being able to sand close to your layout lines will make finial finishing easier without heat build up and less dust. Fitting and finishing recoil pads in the same way is quick and easy. Setting the “toe angle” or the “heel angle” is easy and positive locking with the Torx screw and wrench. Complete with mounting screws and Torx wrench.

LOP Gauge